Hang Your Skateboard Without Drilling Into the Deck
Turn an old deck into a wall lamp using the truck holes already there. No fresh holes in the wood, so the scratches and graphic stay as they are.
Antoine Schweitz
Your old deck is leaning behind the bedroom door, nose chipped, one truck still hanging from two bolts. Every time you move it, a little line of grip tape dust lands on the floor. You keep telling yourself you will ride it again. You probably won't.
The obvious move is to put it on the wall. Then you look at the graphic, remember what you paid for the deck, and decide against sending a screw through it. Fair enough. A board can take curbs, rails, and rough concrete, but a fresh hole through the middle still feels wrong.
A basic wall mount can create the same problem if it expects you to drill into the wood. Adhesive mounts avoid that, but they ask you to trust a strip of glue with a full deck hanging over your bed or record shelf. That is not a bet you need to make.
I make Lightwheel for this exact situation. The kit turns your own deck into a wall lamp, using only holes already there, and the board itself is not included.
First, take the trucks off. If the deck has been sitting for years, wipe the underside and clean the grip tape around the mounting holes. You do not need to sand anything, add new holes, or cover the old marks. They are part of the board.
Pick the side you want facing the room. Maybe it is the bottom graphic with a scraped tail and wax along one edge. Maybe it is the black grip with one crooked sticker near the front bolts. Both work, and you can change your mind later without leaving damage behind.
Before fixing it to the wall, hold the deck where you think it belongs. Check the outlet, the cable path, and the height. A board over a low cabinet feels different from one squeezed above a door. Give the shape some room, especially around the kicked nose and tail.
Then mount it. The wall fixing depends on your wall, but the deck itself needs no fresh hole, wood dust, or pile of mystery hardware. The whole setup should take about five minutes. Once it is up, the deck stops being clutter you move from corner to corner. It becomes something you see every day.
The light changes the job of the board without erasing its old one. Scratches stay visible. Pressure cracks around the bolt holes still tell you how hard it was ridden. At night, the glow gives the wall a softer edge than a bare ceiling bulb, and the deck finally earns the space it has been taking up.
That matters if the board came from a trip, a local shop that closed, or a period of your life you do not want to throw in a bin. Keeping it does not have to mean stacking it under newer decks. It can stay intact and still do a job.
The hardware lines up with the standard truck pattern and passes through those existing bolt holes. The power cable uses that same route, so there is no drilling into the deck and no cutout to hide later. It fits any deck, and because the setup is plug and play, you connect it, hang the board, and plug it into the wall.